Polycom CX5100 Administrator's Manual page 61

Logging Level, Change, and Render Parameters
Parameter
log.level.change.xxx
Control the logging detail level for individual components. These are the input filters into the internal memory-based
log system. Possible values for xxx are acom, ares, app1, bluet, bdiag, brow, bsdir, cap, cdp, cert, cfg, cipher, clink,
clist, cmp, cmr, copy, curl, daa, dapi, dbs, dbuf, dhcpc, dis, dock, dot1x, dns, drvbt, ec, efk, ethf, flk, h323, hset,
httpa, httpd, hw, ht, ib, key, ldap, lic, lldp, loc, log, mb, mobil, net, niche, ocsp, osd, pcap, pcd, pdc, peer, pgui, pmt,
poll, pps, pres, pstn, ptt, push, pwrsv, rdisk, res, rtos, rtls, sec, sig, sip, slog, so, srtp, sshc, ssps, style, sync, sys, ta,
task, tls, trace, ttrs, usb, usbio, util, utilm, wdog, wmgr, and xmpp.
log.level.change.prox
Initial logging level for the Proximity log module.
log.level.change.ptp
Initial logging level for the Precision Time Protocol log module.
log.render.file
Set to 1. Polycom recommends that you do not change this value.
log.render.file.size
Maximum size of flash memory for logs in Kbytes. When this size is about to be exceeded, the system uploads all
logs that have not yet been uploaded, and erase half of the logs on the system. The administrator may use web
browser to read all logs on the system.
log.render.file.upload.append
If set to 1, use append mode when uploading log files to server.
Note: HTTP and TFTP don't support append mode unless the server is set up for this.
log.render.file.upload.append.limitMode
Behavior when server log file has reached its limit. delete=delete file and start over stop=stop appending to file
log.render.file.upload.append.sizeLimit
Maximum log file size that can be stored on provisioning server in Kbytes.
log.render.file.upload.period
Time in seconds between log file uploads to the provisioning server.
Note: The log file is not uploaded if no new events have been logged since the last upload.
Polycom, Inc.
Permitted Values
0 to 6
0 - 6
0 - 6
0 or 1
positive integer, 1 to 180
0 or 1
delete, stop
positive integer
positive integer
Configuration Parameters
Default
4
4
4
1
32
1
delete
512
172800
61