Sched - Polycom CX5100 Administrator's Manual

Logging Level, Change, and Render Parameters (continued)
Parameter
log.render.level
Specifies the lowest class of event rendered to the log files. This is the output filter from the internal memory-based
log system.
The log.render.level maps to syslog severity as follows:
0 SeverityDebug (7)
1 SeverityDebug (7)
2 SeverityInformational (6)
3 SeverityInformational (6)
4 SeverityError (3)
5 SeverityCritical (2)
6 SeverityEmergency (0)
log.render.realtime
Set to 1. Polycom recommends that you do not change this value.
log.render.stdout
Set to 0. Polycom recommends that you do not change this value.
log.render.type
Refer to the table Event Timestamp Formats
<sched/>
The system can be configured to schedule certain advanced logging tasks on a periodic basis. Polycom
recommends that you set the parameters listed in the next table in consultation with Polycom Technical
Support. Each scheduled log task is controlled by a unique parameter set starting with log.sched.x where x
identifies the task. A maximum of 10 schedule logs is allowed.
Logging Schedule Parameters
Parameter
log.sched.x.level
Event class to assign to the log events generated by this command. This needs to be the same or higher than
log.level.change.slog for these events to display in the log.
log.sched.x.name
Name of an internal system command to be periodically executed. To be supplied by Polycom.
log.sched.x.period
Seconds between each command execution. 0=run once
log.sched.x.startDay
When startMode is abs, specifies the day of the week to start command execution. 1=Sun, 2=Mon, ..., 7=Sat
Polycom, Inc.
Permitted Values
0 to 6
0 or 1
0 or 1
0 to 2
for timestamp type.
Permitted Values
0 to 5
alphanumeric string
positive integer
0 to 7
Configuration Parameters
Default
1
1
0
2
Default Value
3
15
7
62