Polycom CX5100 Administrator's Manual page 50

Device Parameters (continued)
Parameter
device.net.cdpEnabled
If set to 1, the system attempts to determine its VLAN ID and negotiate power through CDP.
device.net.dot1x.anonid
EAP-TTLS and EAP-FAST only. The anonymous identity (user name) for 802.1X authentication.
device.net.dot1x.enabled
If 0, 802.1X authentication is disabled. If 1, 802.1X authentication is enabled.
device.net.dot1x.identity
The identity (user name) for 802.1X authentication.
device.net.dot1x.method
Specify the 802.1X authentication method, where EAP-NONE means no authentication.
device.net.dot1x.password
The password for 802.1X authentication. This parameter is required for all methods except EAP-TLS.
device.net.etherModeLAN
The LAN port mode that sets the network speed over Ethernet. HD means half-duplex and FD means full duplex.
Note: Polycom recommends that you do not change this setting.
device.net.etherModePC
The PC port mode that sets the network speed over Ethernet. If set to Disabled, the PC port is disabled. HD means
half duplex and FD means full duplex.
device.net.etherStormFilter
Polycom, Inc.
1
1
1
1
1
1
1
1
Configuration Parameters
Permitted Default
Values
0 or 1
string
0 or 1
string
EAP-None,
EAP-TLS,
EAP-PEAPv0-
MSCHAPv2,
EAP-PEAPv0-
GTC,
EAP-TTLS-MS
CHAPv2,
EAP-TTLS-GT
C, EAP-FAST,
EAP-MD5
string
Auto, 10HD,
10FD, 100HD,
100FD,
1000FD
Disabled, Auto
Auto, 10HD,
10FD, 100HD,
100FD,
1000FD
0 or 1
50