Diags - Polycom CX5100 Administrator's Manual

Device Parameters (continued)
Parameter
The SNTP server from which the system obtains the current time.
device.syslog.facility
A description of what generated the log message. For more information, see
device.syslog.prependMac
If 1, the system's MAC address is prepended to the log message sent to the syslog server.
device.syslog.renderLevel
Specify the logging level that displays in the syslog. Note that when you choose a log level, you are including all
events of an equal or greater severity level and excluding events of a lower severity level. The logging level you
choose determines the lowest severity of events to log.
0 or 1: SeverityDebug(7). 2 or 3: SeverityInformational(6). 4: SeverityError(3). 5: SeverityCritical(2). 6:
SeverityEmergency(0).
device.syslog.serverName
The syslog server IP address or domain name string.
device.syslog.transport
The transport protocol that the system uses to write to the syslog server. If set to None, transmission is turned off but
the server address is preserved.
1
Change causes system to restart or reboot.
<diags/>
Use these parameters to enable and set up the remote packet capture feature.
Remote Packet Capture Parameters
Parameter
diags.dumpcore.enabled
When enabled, the system generates a core file if it crashes. When disabled, the system does not generate a core
file when it crashes. The default value is 1, enabled.
diags.pcap.enabled
Enable or disable all on-board packet capture features.
diags.telnetd.enabled
Enable or disable all on-board packet capture features using telnet.
Polycom, Inc.
1
1
Permitted Values
1 0 or 1
0 or 1
0 or 1
Configuration Parameters
Permitted Default
Values
0 to 23
RFC 3164.
0 or 1
0 to 6
IP address or
domain name
string
None, UDP,
TCP, TLS
Default
1
0
0
55