Table of Contents
Advertisement
A.3 Cabling
1. Locate the cable bulkhead (70-32020-01). Refer to Figure A–4 when making the
cable connections.
2. Pull back the interlock cable to the bulkhead and connect it to the
reset/interlock/power harness (17-04305-01). See
3. Carefully pull back the white cable to the bulkhead and connect it to the
reset/interlock/power harness. See
4. A ribbon cable (17-04306-01) is attached to the bulkhead. Connect the other end
of this cable to J14 on the system bus to PCI bus bridge module. See
access the module, remove the three screws that secure the PCI card cage cover
and slide the cover away from the drawer.
5. The 12 V power cable is part of the reset/interlock/power harness on the
bulkhead. Plug the cable into the connector near the CD drive. See
6. The SCSI cable (17-04306-01) has two connectors. Remove the terminator
connector. Connect the SCSI connector to the bulkhead (two screws). See
7. Fasten the bulkhead to the chassis by installing the two screws. To access the
two screw holes, slide the rear cover away. After you install the bulkhead, slide
the rear cover to its original position.
NOTE: Be sure that all cabling is positioned away from the fan assembly.
8. At the bottom of the system drawer, slide the old control panel tray back in place
and fasten it to the system drawer (four screws).
Cabinet to Pedestal System Drawer Conversion
.
.
. To
.
.
A-5
Advertisement
Table of Contents
