Table of Contents
Advertisement
1. Locate the proper mounting holes (cabinet front and rear) and insert the U-nuts
over the holes. Note that there are two types of support rails; one support rail
has two snap latches and the other has none. The support rails with snap latches
must be installed on the right side of the cabinet when viewed from the cabinet
front. In Figure B–2 the support rails installed will hold the first system drawer.
2. At the rear of the cabinet, line up and assemble the support bracket with the rail
mounting holes, leaving the two side-mounted screws loose.
3. At the front of the cabinet, install the support rail on the two screws on the side
of the support bracket and align with front rail mounting holes. Fasten the
support rail to the mounting rail by installing the topmost and lowermost screws.
4. Tighten side mounting screws and secure support rail to bracket.
5. Install the other support rail.
Using H9A10-EC Cabinets
B-5
Advertisement
Table of Contents
