Table of Contents
Advertisement
WARNING: Before mounting the system drawer on the slide tray, ensure that the
cabinet stabilizer is in place.
WARNING: The system drawer, fully configured, weighs 45 kg (100 lbs). Two
people are required to install the system drawer in the cabinet.
1. Extend the slide tray to its fully extended position. The slide locking levers lock
when the slides are fully extended.
2. Lift the system drawer just above the slide tray and then move it back and onto
the slide tray.
3. Carefully position the system drawer until the four mounting holes in the bottom
of the drawer line up with the four mounting holes in the bottom of the slide
tray.
4. Secure the drawer using four screws
Two cable clamps go on each screw under the left side of the slide tray and one
cable clamp goes on each screw under the right side of the slide tray.
5. Install the cable clamps
the left and right sides using flat washers
go on the left stud and one cable clamp goes on the right stud.
, flat washers
on the two studs located underneath the slide tray on
and kepnuts
Installing Components in Cabinet
, and cable clamps
.
. Two cable clamps
4-7
Advertisement
Table of Contents
