1. Fully extend the slides, then lift the slide tray
races
fit into the front end
2. Push the slide tray into the slides until it stops. Push in on the two locking
levers
if necessary and then push the slide tray into the cabinet.
3. Ensure the slide tray slides smoothly in and out of the cabinet.
4. Tighten the screws that secure each of the rear side brackets and nut plates to the
rear rails.
5. Tighten the screws that secure each of the front side brackets and nut plates to
the front rails.
and position it so that the inner
of the slides (see Figure 4–2).
Installing Components in Cabinet
4-5