Table of Contents
Advertisement
1. Using an adjustable wrench or your hand, lower and adjust the leveler feet (see
Figure 2–5). Once the cabinet is level, lock each of the leveler feet in place by
tightening the locknut at the top of each foot.
2. At the front of the cabinet, pull out the stabilizer bar from underneath the
cabinet (see Figure 2–4). Adjust the leveler foot at the end of the stabilizer bar.
WARNING: Only DIGITAL Customer Service representatives or customer
maintenance personnel who are familiar with computer hardware
should slide system drawers out of the cabinet. Personnel should be
experienced and trained in installing computers and related equipment.
Before pulling a system drawer out, make sure that the stabilizer bar is
fully extended; then adjust the leveler foot at the end of the bar so that
it touches the floor.
Figure 2–5 Leveler Foot Adjustment
Screw
Leveler
Foot
PK-0643-96
Preparing the Cabinet
2-9
Advertisement
Table of Contents
