A.2 Remove the Control Panel
1. Remove the cover over the power supplies (2 screws). See Figure A–2. You will
reuse this to cover the new control panel tray after installation.
Figure A–2 Removing the Cover
2. At the bottom of the system drawer, remove the four screws that secure the
control panel tray to the drawer (see Figure A–3).
3. Pull out the control panel tray and remove the control panel by removing the two
screws that attach it to the tray.
4. Disconnect the reset cable connector, the interlock cable connector, and the
ribbon cable connector from the control panel. Note the cable connections.
Cabinet to Pedestal System Drawer Conversion
PK-0693-97
A-3