4.2.4 Install Interlock Actuator Assembly
Figure 4–6 Installing the Interlock Actuator
1. Mount the interlock actuator
kepnuts
(see Figure 4–6).
2. Remove the screws securing the bottom mounting bracket
3. Slide the mounting bracket off the bottom of the vertical bar.
4. Slide the stabilizer bracket
5. Slide the actuator latch
6. Replace the bottom mounting bracket
2. Do not tighten.
7. Secure the stabilizer bracket to the left rear rail with two truss-head screws
8. Position the actuator latch
tighten the two screws to secure the latch to the vertical bar.
9. Tighten the screws to secure the bottom mounting bracket.
4-12
Configuration and Installation Guide
1
2
LJ-05550.TI0
on the left rear of the slide tray using two
onto the bottom of the vertical bar.
onto the bottom of the vertical bar.
and install the screws removed in step
to properly engage the interlock actuator
(see Figure 4–7).
.
, and