Table of Contents
Advertisement
1. Loosen the three screws and nuts
assemblies (see Figure 4–1). This allows the length of the slide assemblies to be
adjusted between the front and rear mounting rails.
2. Locate the right slide assembly.
3. Place the front slide bracket on the inside of the right front rail and align the
holes from the bottom of the nut plate
right front rail.
4. Install one screw
and one washer
right front rail. Do not tighten.
5. Place the rear slide bracket on the inside of the right rear rail and align the holes
from the bottom of the nut plate
rear rail.
6. Install one screw and washer in the first hole to secure the rear slide bracket to
the right rear rail. Do not tighten.
7. Install four truss-head screws
the right rear rail. Do not tighten.
8. Tighten the three pan-head screws and hexnuts
bracket to the right slide assembly.
9. Attach the left slide assembly to the left front and rear rails by repeating steps 1
through 8.
10. Tighten all screws only enough to allow play for the slides to align when the
slide tray is installed in the cabinet.
securing the rear slide bracket to the slide
with the four slide bracket holes on the
to secure the front slide bracket to the
with the four slide bracket holes on the right
to secure the rear slide bracket and nut plate to
that secure the right rear slide
Installing Components in Cabinet
4-3
Advertisement
Table of Contents
