Table of Contents
Advertisement
1. Position the cabinets side by side.
2. To remove a side panel, remove the two M5 screws at the bottom front and rear
of the cabinet (see ).
3. Remove the side panel by lifting it up and away from the cabinet. The side
panel rests on the hanger bracket located at the top of the cabinet (see
4. Repeat steps 2 and 3 on the other cabinet. Install the keybuttons (see ).
Figure 2–7 Installing the Joiner Hardware
5
6
8
3
4
7
PK-0648-96
Preparing the Cabinet
).
2-11
Advertisement
Table of Contents
