Table of Contents
Advertisement
1. Remove the top screw
panel assembly (see Figure 4–4). Save the screws for later use.
2. Align the two holes at the bottom of the left catch bracket
in the left front edge of the slide tray.
3. Secure the left catch bracket to the slide tray with two truss-head screws
4. Secure the left catch bracket to the system drawer by replacing the screw
removed in step 1.
5. Attach a cable clamp
and kepnuts
.
6. Attach a cable clamp to each standoff on the left catch bracket with flat washers
and kepnuts.
7. Align the two holes at the bottom of the right catch bracket
holes in the right front edge of the slide tray.
8. Secure the right catch bracket to the slide tray with two truss-head screws.
9. Secure the right catch bracket to the system drawer by replacing the screw
removed in step 1.
10. Attach a cable clamp to each of the studs on the right catch bracket with flat
washers and kepnuts.
on the left and right side of the system drawer control
to each stud on the left catch bracket with flat washers
Installing Components in Cabinet
with the two holes
.
with the two
4-9
Advertisement
Table of Contents
