Adjusting Steering Head Bearing Play - KTM 250 SX 2024 Owner's Manual

11.16

Adjusting steering head bearing play

Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
H01167-01
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust steering head bearing play.
–
Check the steering head bearing and change if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, steering head,
top
–
Using a plastic hammer, tap lightly on the upper triple clamp
S05338-10
to avoid stresses.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
Finishing work
–
Check steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Mount the handlebar cushion.
SERVICE WORK ON THE CHASSIS 11
1
.
2
.
3
.
M20x1.5 12 Nm (8.9 lbf ft)
1
.
M8 17 Nm (12.5 lbf ft)
2
.
M8 20 Nm (14.8 lbf ft)
p. 56)
( p. 57)
( p. 57)
p. 48)
p. 48)
Loctite ® 243™
p. 48)
57