Adjusting Steering Head Bearing Play - KTM Freeride E-XC 2019 Owner's Manual

Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the
bearing seats in the frame can become damaged over time.
13.12

Adjusting steering head bearing play

Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the protection cap. (
–
Raise the motorcycle with a lift stand. (
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
H01167-01
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust steering head bearing play.
» If detent positions can still be detected:
–
Change the steering head bearing.
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the protection cap. (
–
Raise the motorcycle with a lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
A00210-10
–
Tighten screws
SERVICE WORK ON THE CHASSIS 13
p. 43)
p. 69)
p. 107)
p. 71)
p. 108)
p. 69)
p. 43)
p. 69)
p. 107)
p. 71)
1 2
. Remove screw .
3
.
M20x1.5 12 Nm (8.9 lbf ft)
1
.
p. 57)
( p. 65)
( p. 65)
p. 57)
p. 57)
65