Removing The Processing Tray Unit - Canon Inner Finisher-H1 Service Manual

CAUTION:
Points to Note when Installing the Upper Feed Guide
Unit
When attaching the Upper Feed Guide Unit [1], keep
standing the Feed Guide [2] as shown in the figure.
[2]
Removing the Processing
Tray Unit
■ Preparation
1. Remove this machine from the host machine.
"Removing this Machine from the Host Machine" on
page 41
2. Remove the Front Cover
Cover Unit" on page 55
3. Remove the Rear Cover."Removing the Rear Cover"
on page 55
4. Remove the Delivery
Tray" on page 56
5. Remove the Upper Feed Guide
Upper Feed Guide Unit" on page 59
6. Remove the Tray Guide
Guide Cover" on page 57
7. Remove the Staple-free Staple
Staple-free Staple Unit" on page 65
[1]
Unit."Removing the Front
Tray."Removing the Delivery
Unit."Removing the
Cover."Removing the Tray
Unit."Removing the
4. Parts Replacement and Cleaning
■ Procedure
1. Remove the Front Tray Rack [1] / Rear Tray Rack [2].
[2]
NOTE:
How to assemble the Front Tray Rack and Rear Tray Rack
1. Insert the Front Tray Rack [1] and Rear Tray Rack [2]
at the Guide.
2. Release the latch and move the Tray Rack to the
bottom.
3. Check the phase position between the Front Tray
Rack [1] and Rear Tray Rack [2] with the lines marked
[3] on them. When the phase position is different,
follow the step 1) again.
[B]
[2]
2. Remove the Cable Guide [1].
• 1 Screw [2]
• 3 Connectors [3]
• 2 Cables [4]
60
[1]
[A]
[1]