Service Procedures
SP 3 Check Mechanical
Attachments
This check is to preserve the safety and
performance of the product.
Check:
(a) Lift arm and hook
(b) Safety catch
(c) Drain, overfill cover
(d) Tub foots, floor attachment
(e) Internal framework and actuators,
especially the swing actuator connection to lift
arm
(f) Air jets (with air-spa)
(g) Chassis (chair) Shall not unhook from the
catch even if it gets a hard stroke- if this is the
case - replace
NOTE
Screws and bolts attached with Loctite should not
be checked by tools but manually to test if the
jointing/component is securely fitted.
If
tightening
is needed and Loctite is previously
used new Loctite must be applied. Proceed ac-
cording to the Loctite manufacturers instructions.
See also "Lockings, Lubrication and Torques"
on page 47 and "Tools" on page 52.
a
c
e
f
8
MRM Malibu/Sovereign
b
d
g