Arjohuntleigh Malibu Sovereign Maintenance And Repair Manual page 41

MRM Malibu/Sovereign
7. Remove tape (p)
8. Attach the o-ring (q) from top through the
hole on the tub
9. Attach the bearing (r) to the tub, might be
necessary to flex the tub a little
10.Attach screw and new locking nut (s) with
top attachment (t)
11.Lubricate surface of lift arm (u) (below
bushings)
12.Attach lift arm together with bushings (v)
13.Remove tool or tape holding PCB and attach
screws (w) holding top bushings and PCB
14.Attach screws (x) holding the lift arm, use
Loctite
NOTE
Check that the screws (x) are properly
attached to the top attachment (t) by pulling
the arm upwards.
15.Lower the tub
16.Attach the chair on lift arm
17.If out of position the actuator will find the
correct position if operated to the lowest
position inside tub. When searching for the
correct zero-position the movement may be
slow but it will always reach their zero-
position
18.Attach the tub front and inner cover on lift
arm side
t
s
x
v
w
u
41
Service Procedures
h
p
r
q