Perform Full Feature Functionality Test - Arjohuntleigh Malibu Sovereign Maintenance And Repair Manual

Service Procedures
SP 15 Perform a Full Feature
Functionality Test
Final service check
Function
Shower handle and holder
All functions
Hi/lo full stroke
Temp setting shower max
Temp setting fill max
Autodisinfection
Disinfection handle
LED indication on tub con-
trol panel
B A
D
F
Activation
Buttons on tub and
hand control
Mechanical scalding
protection
Button on tub panel
to be pressed for 5
seconds
Button on tub panel
to be pressed for 5
seconds plus trigger
pulled on handle
Connected to mains
Connected to mains
Lock button active
Disinfection button
activated.
C
Disinfection button
deactivated
Scalding protection
active: Water temp.
>45° C for 10 sec.
Lift out activated on
hand control but tub
is not in lowest posi-
E
tion
(only with Hi/lo)
In Service mode:
DIP switch 3 in pos
OFF
DIP switch 4 in pos
OFF
Disconnected from
mains
Demands for approval
No leaks or cracks
Activation/deactivation
No noise or "jumps"
41°C -1°C (106°F-1.8°F)
44°C -1°C (111°F-1.8°F)
Chair raising from tub bottom to 300 mm.
(15sec.) if not already up
Disinfection air-lines (10sec.)
Reaction time in pump :120 sec. when shor-
tend by pressing button twice else 155sec.
Rinse (40sec.)
Blower running (40sec.)
With autodisinfection:
Flow can be shut off by pressing the button
(Flow -min 120 sec. when interrupted on
button,-max 155 sec. without interruption.
With manual disinfection only:
Flow can be shut off by pressing the button
(Flow: time-out 5 minutes.)
A:Steady green or flashing green
B: steady green
C: steady yellow
D:steady green (level OK)
D:flashing green and beeping (level low)
D:flashing green (with autodisinfection)
D:No light (with manual disinfection)
E: flashing yellow
F: flashing yellow
E: flashing yellow
A:Battery status
Steady green= Battery OK
26
MRM Malibu/Sovereign