Arjohuntleigh Malibu Sovereign Maintenance And Repair Manual page 40

Service Procedures
Assembly of lift arm
For specification of lubrication and torques
see page 47 and page 52
1. Lubricate bearings (a) and inside outer pro-
file (b) if necessary. Attach the top rotation
bearing with the bottom rotation bearing in
the lower attachment (c) and push up outer
profile with actuator in a vertical position,
be sure not to scratch the painting of the out-
er profile.
2. Locate the actuator attachment (d) and
fasten clevis pin and cotter pin(e) together
with microswitch (f) use Loctite on screws
for microswitch
3. Attach the actuator attachment with three
long 16mm screws (g), use special tool
4. Fasten the lower attachment (h) with six
short 12 mm screws (i) together with the
guide plate (j) , use torque
5. Fasten the swing actuator (k) note position
of rotation plate (l) with wings upward
against actuator. Nut (m) shall be locked
with Loctite
6. Attach cable to lift arm PCB (n) and connect
actuator outside control box (o), strap
cabling. Check that the actuator works.
b
c
l
m
40
MRM Malibu/Sovereign
a
a
e
d
f
e
i
h j
g
k
n
o