Arjohuntleigh Malibu Sovereign Maintenance And Repair Manual page 45

MRM Malibu/Sovereign
SP 29. Generic Glue Repair
Instruction
his instruction is a generic glue instruction
when parts / brackets has separated from the
glass fiber and the technician performing the
procedure must therefore adapt these generic
instructions to their specific repair.
Repair Material
The following tools and components are
needed:
• Adhesive (6907960 )1 pcs.
• Adhesive gun (69079619) 1 pcs.
• Acetone Minor qty.
• Tape measure 1pcs.
• Rags Minor qty.
• Quick clamps 2 pcs.
• Cardboard or paper towels Minor qty.
Glue Instruction
1. Gain access to the loose part by removing
covers and/or panels.
2. Locate the loose bracket/s
3. Identify the earlier position of the bracket
using old glue and mark out the position (by
scratching or felt tip marker)
4. Remove loose glue
5. Determine how you could fixate the item in
the correct position for 1 hour before going
to point 6 (quick clamp, support bracing,
tape etc.) This does not require much force,
only enough to fixate the bracket without
pushing the adhesive from the bonding
points
6. Both bracket and fiberglass tub shell
bonding surfaces needs to be cleaned using
acetone on rags to ensure good
adhesion.
7. Cover door rails, motor, floor etc. with
cardboard or paper towels in case of
dripping glue
8. The adhesive has a limited "open" time so
once you start dispensing adhesive through
the dosing pipe you must complete the
45
Service Procedures