Table of Contents
Advertisement
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove ST.
This section describes the mechanical installation of the NextMove ST.
3.1.1 Location requirements
You must read and understand this section before beginning the installation.
CAUTION: To prevent equipment damage, be certain that input and output signals
CAUTION: To ensure reliable performance of this equipment be certain that all
CAUTION: Avoid locating the NextMove ST immediately above or beside heat
CAUTION: Avoid locating the NextMove ST in the vicinity of corrosive substances or
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
The NextMove ST is designed to be mounted indoors, permanently fixed and located.
H
The NextMove ST must be secured by the slots in the metal carrier.
H
The NextMove ST must be installed in an ambient temperature of 0°C to 40°C (32°F to
H
104°F).
The NextMove ST must be installed in relative humidity levels of less than 80% for
H
temperatures up to 31°C (87°F) decreasing linearly to 50% relative humidity at 40°C
(104°F), non-condensing.
The NextMove ST must be installed where the pollution degree according to IEC664 shall
H
not exceed 2.
There shall not be abnormal levels of nuclear radiation or X-rays.
H
MN1929
are powered and referenced correctly.
signals to/from the NextMove ST are shielded correctly.
generating equipment, or directly below water steam pipes.
vapors, metal particles and dust.
www.supportme.net
Basic Installation
3
Basic Installation 3-1
3
Advertisement
Table of Contents
