Remote Midi Storage Of Vs-2400Cd Settings; Sending Sysex Bulk Dump Data - Roland VS-2400CD Owner's Manual
24tr/96khz/24-bit digital studio workstation
Hide thumbs
Also See for VS-2400CD:
- Appendices (156 pages) ,
- Service notes (49 pages) ,
- Mixer block diagram (1 page)
Table of Contents
Advertisement
23—MIDI and Synchronization
To enable Control Change reception on the VS-2400CD:
1. Using a MIDI cable, connect the VS-2400CD's MIDI IN jack to the external device's
2. Navigate to the MIDI parameter screen (Page 285).
3. Set MIXER CONTROL TYPE to C.C. ("Control Change").
4. If you want to edit effects using NRPNs, turn on the EFFECT C.C. Rx Sw ("EFFECT
Remote MIDI Storage of VS-2400CD Settings
You can transmit scenes, EZ Routing templates and user effect patches from the
VS-2400CD as SysEx bulk dump data that can be stored in an external MIDI storage
device—or a sequencer—and loaded back into the VS-2400CD at a later time. The
VS-2400CD's bulk dump operations are performed on its MIDI BULK DUMP screen.
Bulk-dumping scene, EZ Routing or effect patch data doesn't remove it from the
VS-2400CD's memory. It merely allows you to store a copy of the data externally.
In order to transmit MIDI bulk dump data, the SysEx. Tx Sw parameter on the MIDI
PARAMETER screen (Page 285) must be turned on. To receive bulk dump data, the
SysEx. Rx Sw parameter on the same screen must also be turned on.
To ensure the successful re-loading of bulk dump data, read "A Note About SysEx ID
Numbers" on Page 286.
Sending SysEx Bulk Dump Data
1. Using a MIDI cable, connect the VS-2400CD's MIDI OUT/THRU jack to the device
2. Navigate to the MIDI PARAMETER screen ((Page 285).
3. Set MIDI OUT/THRU to Out.
4. Press F5 (BlkDmp)—the MIDI BULK DUMP screen appears.
5. To include scene data in the dump, turn on the SCENE section's BULK Tx Sw.
6. Set the SCENE section's BULK Tx TARGET parameter to:
290
MIDI OUT jack.
Control Change Receive Switch") parameter.
to which you want to transmit the SysEx bulk dump.
When you bulk-dump data from the VS-2400CD, all data selected for transmission
on this screen is included in the dump. Therefore, you'll need to select what you
want to transmit in the dump. The screen is divided into three parts: SCENE, EZR
Usr TMplt ("EZ Routing User Templates") and Usr FX ("User Effect Patches"). Each
section has a BULK Tx ("Bulk Transmit") Sw on/off parameter, and a BULK Tx
TARGET ("Bulk Transmission Target") parameter.
•
ALL—to include all of the current project's scenes in the dump.
•
(Scene XX)—to select a single scene to dump.
www.RolandUS.com
Roland VS-2400CD Owner's Manual
Advertisement
Table of Contents
