Roland VS-2400CD Owner's Manual page 162

11—Input and Track Channel Tools
To return to the normal CH EDIT display, press F6 (CH.V).
At the bottom of the Parameter View screen is a set of four tabbed layers that contain an
F button for each of the viewable parameters or parameter groups for the current
channel. Press the desired F button. To reveal an F button that's currently hidden, tap
PAGE until the tabbed layer it's on appears. There are also F buttons for the DYN and
EQ screens that show all their parameters at once, as described below.
The F2 (Surrnd) button is active only when the UTILITY menu's SURROUND MIX Sw
parameter (Page 311) is turned on.
At the left side of the screen, you'll see the displayed parameter's name. If a group of
related parameters is in view, each is labeled at the left side of the screen.
The Parameter View screen can't always show all of the channels' settings for a
parameter at the same time. When all of the channels won't fit onscreen at once, you'll
see an arrow pointing to the right at the right-hand side of the screen. You can press
or click the arrow with your mouse to view the remaining channels, or
In some cases, you'll see up and down arrows at the left edge of the screen. In general,
these mean that there's more to see above and/or below the current view—you can
press
one of the arrows depends on what's being viewed.
When the PRM.V screen shows:
DYN parameters
EQ parameters
FXIns parameters
AUXSnd parameters
If you edit a parameter while in Parameter View, its channel automatically becomes the
currently selected channel.
Hold down SHIFT and press
Parameter View screen, respectively.
Hold down SHIFT and press
screen for the previous or next channel, respectively.
162
or , or click either arrow with your mouse. What happens when you click
www.RolandUS.com
Use the up and/or down arrows to view:
the DYN screen's expander and compressor
parameters. See Page 152. At the top of the PRM.V
section of the display, you'll see the name of the
currently displayed set of dynamics parameters.
When the dynamics processor is set to compressor,
all expander-related parameters are hidden, and vice
versa.
all of the EQ screen's parameters. See Page 157.
the effect insert settings—and patch name—for each
of the available effects, one at a time. See Page 210. At
the top of the PRM.V section of the display, you'll see
the name of the currently displayed effect.
the Aux send settings for each of the eight Aux
busses, one at a time. See Page 148. At the top of the
PRM.V section of the display, you'll see the name of
the currently displayed Aux send.
or to view the previous or next parameter's
or to view the currently settings' Parameter View
Roland VS-2400CD Owner's Manual
to go back.