Multi-Channel Strip Views; The Multi-Channel View Master Strip - Roland VS-2400CD Owner's Manual

33—VGA Main Display Mixer Views
8. Channel Fader
The position of the channel fader sets the level of signal coming out of
the channel. Moving the onscreen fader is the same as moving the
channel's physical fader on the VS-2400CD.
9. MONO Switch
Click this button—so it lights—to collapse the effect processor's
stereo output to a mono signal.

Multi-Channel Strip Views

The multi-channel strip views show a detailed view of the set of 12 channels currently
selected with the FADER buttons. To view the desired set of multi-channel strips, click
the desired FADER button, described below. There are eight onscreen FADER buttons.

The Multi-Channel View MASTER Strip

All of the multi-channel views share a common MASTER strip. This
section describes what you'll find in this strip.
1. FADER/V.FDR buttons
These buttons perform the same job as the
VS-2400CD's top-panel FADER buttons. To view a set
of 12 channel strips, click the corresponding button. To
view the V.FADERS, click V.FDR.
2. MON (MONITOR) Balance Knob
Drag the MON (for "MONITOR") balance knob up or down to shift the
MONITOR bus output leftward or rightward, respectively.
3. MON (MONITOR) Level Knob (Info Only)
The MON (for "MONITOR") knob shows the level of the MONITOR bus.
This level can be adjusted only using the VS-2400CD's MONITOR knob.
4. MASTER Bus Effect Insert
To insert an effect processor on the MASTER bus, click its number—the
MASTER EFFECT INSERT screen appears.
428 www.RolandUS.com
The FADER PAN button lets
you use the faders for
stereo placement of the
selected channels' signals.
Since it doesn't select
channels itself, it's not
shown here.
Roland VS-2400CD Owner's Manual
226
224
5.
134
213
1.
2.
3.
4.
6.
7.
8.