The Ez Routing Output Assign Screen; Making Connections On The Ez Routing Patch Bay Screen - Roland VS-2400CD Owner's Manual

On the PATCH BAY screen, you can route the following jacks and connectors to input
channels:
•
•
•
You can also turn phantom power on or off for the XLR input jacks, and activate the
desired digital inputs on this screen, as described on Page 126 and Page 127,
respectively.

Making Connections on the EZ ROUTING PATCH BAY Screen

For the purposes of routing, input jacks and connectors and input channels are treated
as odd/even pairs. These pairs cannot be altered.
1. Use
2. Turn the Time/Value dial to create the desired connection.
Chapter 9 describes in detail how to route inputs to input channels—see Page 132.

The EZ ROUTING OUTPUT ASSIGN Screen

On the EZ ROUTING OUTPUT ASSIGN screen, you can route any of the VS-2400CD's
busses or tracks to output jacks or connectors. The screen's appearance changes slightly
for the two types of routing.
Roland VS-2400CD Owner's Manual
the 16 analog input jacks (XLR and 1/4")
The R-BUS connectors' 8 digital channels
the coaxial digital connector or the optical digital connector (Page 127)
Input jacks and
connectors
Input channel
inputs
, , or to select the desired pair of input channels.
Outputs
When routing busses When routing tracks
www.RolandUS.com
22—EZ Routing
The gray arrows at
the left edge of the
screen show the
direction in which
signal is flowing.
Outputs
279