Monitoring The Recording Busses Directly; Routing A Pair Of Busses To The Stereo Monitor Bus - Roland VS-2400CD Owner's Manual

If the TRACK DIRECT OUT parameter is turned on, turn it off to activate bus routing.
When you do this, routings between tracks and outputs are de-activated, though their
connections remain in place.
4. Use
5. Turn the Time/Value dial to choose the desired pair of busses to be routed to the
If you prefer, you can route busses to outputs by dragging an output pair's connection
box down to the desired bus pair with your mouse.
The coaxial and optical digital outputs are always active, and carry the same signal.

Routing a Pair of Busses to the Stereo MONITOR Bus

1. Press EZ ROUTING.
2. If "OUTPUT" isn't above F3, press PAGE repeatedly until it is.
3. Press F3 (OUTPUT)—the OUTPUT ASSIGN screen appears.
MONITOR bus assignment is unaffected by the setting of the TRACK DIRECT OUT
parameter—you can route signals to the MONITOR bus at any time.
4. Press
5. Turn the Time/Value dial to choose the pair of busses to be sent to the stereo

Monitoring the Recording Busses Directly

To listen to the recording busses (Page 57) directly without sending them through their
track channels, assign REC L/R to the MONITOR bus. When you do this:
•
•
Roland VS-2400CD Owner's Manual
The output jack and connector pairs run along the top of the screen, and the bus
pairs run up and down its left edge.
or to select the desired pair of output jacks or digital connectors.
selected output pair—as you turn the dial, the connection box moves up and down
the display, showing you what's routed to the selected pair of outputs.
MONITOR bus
assignment
junction
The assignment of a pair of busses—or a stereo bus—to the stereo MONITOR bus
is shown by the MONITOR bus assignment junction at the left of the output
routing area on the OUTPUT ASSIGN screen as shown above.
to highlight the MONITOR bus assignment junction.
MONITOR bus—as you turn the dial, the connection moves up and down through
the busses on the left side of the display, showing what's being sent to the bus.
All 16 recording busses are combined into a single stereo signal for monitoring.
You can adjust this stereo signal's level using the REC ATT parameter.
21—Working with the VS-2400CD 0utputs
www.RolandUS.com
In this illustration, we've
selected the MONITOR
bus assignment junction,
and the stereo MASTER
bus is selected as the
signal being sent to the
stereo MONITOR bus.
273