Erase; Comp/Exp - Roland VS-2400CD Owner's Manual

AllVTr
Turn AllVTr on if you want to remove the chunk of time from all of the V-Tracks
belonging to a selected track.

ERASE

Use: Mouse, TRACK menu
Erase removes a specified region from a selected track, leaving all of its
other audio where it is.
Why You'd Use Region ERASE
Region ERASE is a really good way to get rid of unwanted audio—wrong notes, noises,
throat-clearing, unwanted chatter and so on—on a track without affecting the rest of its
audio.
Thanks to the VS-2400CD's non-destructive editing, anything you erase is still on your
hard drive if you want it back, until you optimize the project. Use Undo to retrieve it, or
create a new phrase from its original take (see Page 255).
Edit Points
•
•
Make sure there's no audio within 0.5 seconds before the IN point and 0.5 seconds after
the OUT point to ensure a smooth transition.
AllVTr
Turn AllVTr on if you want to remove the audio from all of the V-Tracks belonging to a
selected track. You'll want to do this if each V-Track contains a different performance
attempt, and they all contain the same mistake.

COMP/EXP.

Use: Mouse, TRACK menu
The region COMP/EXP. ("Compression/Expansion") operation allows
you to time-stretch or time-shrink a region, with or without changing
the region's pitch.
Time compression and expansion cannot be used on tracks recorded using the CDR
recording mode.
Since the COMP/EXP. operation makes a new copy of any region it's processing, it can
be performed only when there's sufficient free space on your hard drive.
Roland VS-2400CD Owner's Manual
Before region ERASE
IN
OUT
IN—sets the beginning of the audio segment you're erasing.
OUT—sets the end of the audio segment you're erasing.
20—Region Editing Operations
After region ERASE
IN
OUT
www.RolandUS.com
TRACK menu
F5 (ERASE)
TRACK menu
F1 (CmpExp)
265