LSI 3ware 9750 User Manual page 208

Chapter 11. 3DM2 Reference
196
The physical capacity of the drive. (Note that the capacity as shown
Capacity.
on 3DM2 screen is calculated as 1 KB = 1024. This amount may differ from
the capacity that is printed on the disk drive, where it typically has been
calculated as 1 KB = 1000. Consequently, the capacity of the drive may
appear smaller in the 3DM2 screens. No storage capacity is actually lost; the
size has simply been calculated differently for consistency.)
The type of drive: SATA or SAS.
Type.
The number of the controller phy to which the drive is connected. Click
Phy.
the link to go to the Controller Phy Summary page. (For details, see
"Controller Phy Summary page" on page 199.)
Slot. The number of the enclosure slot in which the drive is located. Click the
link to go to the Enclosure Details page.
Unit. The unit the drive belongs to, if applicable.
Status. The status of the drive: OK, Not Supported, Not Present, and so forth.
If you need help regarding a status displayed here, please contact Technical
Support. For more information, see "Drive Statuses" on page 138.
Note:
In most cases, the status of the drive will not correspond to the status of the
unit, shown on the Unit Information page. Different status information is provided for
drives and for units.
Identify. Check this box to cause the LED for this drive to blink in the
enclosure. If the box is grayed, identify is not supported.
3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2