Installing The Control Panel - Dell EMC PowerEdge R6400 Installation And Service Manual

Related links
Removing a hard drive
Removing the 2.5 inch drive cage
Removing the 3.5 inch drive cage

Installing the control panel

Installing the control panel
Prerequisites
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE: Additional tape maybe required to secure the cables.
Follow the safety guidelines listed in
Steps
1 Route the control panel cable through the cable retention clips.
2 Install the control panel assembly and secure it in place with screws.
Figure 69. Installing the left control panel
86 Installing and removing enclosure components
Safety instructions.