Installing The Chassis Management Board - Dell EMC PowerEdge R6400 Installation And Service Manual

Steps
1 Using the Phillips #2 screwdriver, remove the two screws that secure the chassis management board to the chassis.
2 Sliding the board toward the front of the enclosure, lift the board away after the guide slots are free of the standoffs.
Figure 40. Removing the chassis management board
Next step
Install the chassis management board.
Related links
Removing a power supply unit
Removing the power interposer board

Installing the chassis management board

Installing the chassis management board
Prerequisite
Follow the safety guidelines listed in
Steps
1 Insert the chassis management board into the enclosure, aligning the guide slots with the standoffs on the chassis.
2 Push the board toward the back of the enclosure to align the screw holes on the board and standoffs chassis.
3 Using the Phillips #2 screwdriver, replace the screws to secure the board in place.
Safety instructions.
Installing and removing enclosure components 61