Linking Board; Removing The Linking Board - Dell EMC PowerEdge R6400 Installation And Service Manual

Figure 41. Installing the chassis management board
Next steps
1 Reconnect all the disconnected cables.
2 Install the power interposer board.
3 Install the power supply units.
4 Follow the procedure listed in
Related links
Installing a power supply unit
Installing the power interposer board

Linking board

The linking board connects the sled to the allotted drives on the backplane.

Removing the linking board

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sleds from the enclosure.
4 Remove the fan cage.
Steps
1 Using the Phillips #1 screwdriver, remove the screw that secures the linking board to the enclosure.
2 Lift the linking board out of the enclosure.
3 Disconnect all the attached cables.
62 Installing and removing enclosure components
After working inside your system.
Safety instructions.
Before working inside your system.