Thermal Sensor Board; Removing The Thermal Sensor Board - Dell EMC PowerEdge R6400 Installation And Service Manual

Figure 70. Installing the right control panel
Next steps
1 Reconnect the control panel cable to the midplane.
2 Install the drive cage into the enclosure.
3 Reconnect all the disconnected backplane cables.
4 Install all the removed drives.
5 Follow the procedure listed in
Related links
Installing the 2.5 inch drive cage
Installing the 3.5 inch drive cage
Installing a hard drive

Thermal sensor board

The thermal sensor board is used to the monitor the ambient temperature around the enclosure.

Removing the thermal sensor board

Prerequisites
CAUTION: To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION: You must note the number of each drive and temporarily label them before removal so that you can replace them in
the same locations.
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1 Follow the safety guidelines listed in
After working inside your system.
Safety instructions.
Installing and removing enclosure components 87