Installing The Thermal Sensor Board - Dell EMC PowerEdge R6400 Installation And Service Manual

2 Follow the procedure listed in
3 Remove all the drives.
4 Disconnect all the cables from the backplane.
5 Disconnect the control panel cable from the midplane.
6 Remove the drive cage from the chassis.
Steps
1 Using the Phillips #1 screwdriver, remove the screw that secures the thermal sensor board assembly to the drive cage.
2 Disconnect the cable from the sensor board assembly.
3 Remove the screw that secures the sensor board to the drive cage, and lift the board away.
Figure 71. Removing the sensor board
Next step
Install the sensor board.
Related links
Removing a hard drive
Removing the 2.5 inch drive cage
Removing the 3.5 inch drive cage

Installing the thermal sensor board

Installing the thermal sensor board
Prerequisite
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly on the chassis to prevent them from being pinched or crimped.
1 Follow the safety guidelines listed in
Steps
1 Install the thermal sensor board into the sensor board holder, and using the Phillips #1 screwdriver, secure it to the holder.
2 Connect the cable to the sensor board assembly.
3 Install the sensor board assembly into the drive cage.
4 Replace the screw that secures the sensor board assembly to the drive cage.
88 Installing and removing enclosure components
Before working inside your
Safety instructions.
system.