Control Panel; Removing The Control Panel - Dell EMC PowerEdge R6400 Installation And Service Manual

Figure 66. Cabling the 12 x 3.5 inch backplane
1 backplane
3 signal cable sled 1(BP: BP_SIG1 to left linking board)
5 left linking board
7 SATA cable for sled 2(BP: SATA cable sled 2 to left linking
board)
9 SATA cable for sled 3(BP: SATA cable sled 3 to right linking
board)
11 right linking board
13 linking board connector for sled 4
15 signal cable sled 4(BP: BP_SIG4 to left linking board)

Control panel

Removing the control panel

Prerequisites
NOTE: Observe the routing of the cables on the enclosure as you remove them. You must route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove all the drives.
4 Disconnect all the backplane cables from the linking board and chassis management board.
84 Installing and removing enclosure components
Safety instructions.
Before working inside your
2 SATA cable for sled 1(BP: SATA cable sled 1 to left linking
board)
4 linking board connector for sled 1
6 linking board connector for sled 2
8 signal cable sled 2(BP: BP_SIG2 to left linking board)
10 signal cable sled 3(BP: BP_SIG3 to left linking board)
12 linking board connector for sled 3
14 SATA cable for sled 4(BP: SATA cable sled 4 to right linking
board)
system.