Overview Of Advanced Diagnostics Parameters A To P - Siemens 6DR50 Series Operating Instructions Manual

Parameterizing/addressing
9.3 Parameter overview
9.3.3

Overview of advanced diagnostics parameters A to P

Introduction
These parameters are used to set the extended diagnostics functions of the positioner.
Note
Factory setting
Factory-set parameter values are printed in bold in the following table.
Note
Display
Parameters A to P and their sub-parameters are only displayed when the extended
diagnostics has been activated in parameter "'52.XDIAG' Activating for extended diagnostics
(Page 174)" with setting "On1", "On2" or "On3".
Overview parameter A
Parameter Function
Partial stroke test with the following parameters:
A. PST
A1.STPOS Start position
A2.STTOL Start tolerance
A3.STRKH Stroke height
A4.STRKD Stroke direction
A5.RPMD Ramp mode
A6.RPRT Ramp rate
A7.FLBH Behavior after failed PST
A8.INTRV Test interval
A9.PSTIN Reference stroke time for partial stroke test
AA.FACT1 Factor 1
Ab.FACT2 Factor 2
AC.FACT3 Factor 3
152
Parameter values
0.0 ... 100.0
0.1 ... 2.0 ... 10.0
0.1 ... 10.0 ... 100.0
uP / do / uP do
OFF / On
0.1 ... 1.0 ... 100.0
Auto / HOld / AirIn / AirOu
OFF / 1 ... 365
NOINI / (C)##.# / Fdini / rEAL
0.1 ... 1.5 ... 100.0
0.1 ... 3.0 ... 100.0
0.1 ... 5.0 ... 100.0
Operating Instructions, 09/2014, A5E00074631-12
Unit
%
%
%
%/s
Days
s
SIPART PS2 with and without HART