Table of Contents
Advertisement
2.
INSTALLATION
The 7721AE8-DEE-HD comes with a companion rear plate that occupies two slots in the frame. For
information on mounting the rear plate and inserting the module into the frame see section 3 of the
7700FR chapter.
2.1.
VIDEO CONNECTIONS
HD/SDI IN:
This input BNC connector is used to accept 10-bit serial digital video signals compatible
with the SMPTE 292M or the SMPTE 259M-C standard. The module can be set to a
specific video standard or set to automatically detect.
HD/SDI OUT: This BNC connector is used to output the video as serial component video, compatible with
the SMPTE 292M or SMPTE 259M-C standard (same as input).
BYPASS
This BNC connector is used as program out bypass. The output signal is compatible with
the SMPTE 292M or SMPTE 259M-C standard (same as input). In the event of a power or
module failure, the bypass relay will be activated, maintaining the program video path.
7721AE8-DEE-HD HD-SDI/SD-SDI Audio Embedder with Dolby Encoder
Figure 2-1: 7721AE8-DEE-HD Rear Panel
Revision 1.2
7700 MultiFrame Manual
Page-3
Advertisement
Table of Contents
