Table of Contents
Advertisement
7700 MultiFrame Manual
7721AE8-DEE-HD HD-SDI/SD-SDI Audio Embedder with Dolby Encoder
6.7.4. Dolby-E Encoder Output Routing
These parameters select whether the AES/embedded output will come from "Mixer A" or the Dolby-E
encoder output. This allows the Dolby-E output to be copied to multiple AES outputs.
Audio Processor
DEAR
Output 1 Selection
Output 2 Selection
Output 3 Selection
Output 4 Selection
Output 5 Selection
Output 6 Selection
Output 7 Selection
Output 8 Selection
6.7.4.1.
Output Selection Control
Selects Mixer A output or Dolby-E output.
Audio Processor
DEAR
OUT1
Ch1&2
Dolby-E Encoder
6.8.
CONFIGURING THE HEADPHONE MONITOR
The Headphone Monitor menus are used to configure parameters associated with the headphone jack on
the module. The chart below shows the items available in the Headphone Monitor menu. Sections 6.8.1
to 6.8.2 provide detailed information about each of the menu items.
HVOL
Headphone volume
HSRC
Headphone source
6.8.1. Setting the Headphone Volume
Headphone Monitor
HVOL
HV00 to HV15
Page-28
The following are the default values for each of the input
sources:
OUT1
OUT1 = Ch 1&2
OUT2
OUT2 = Ch 3&4
OUT3
OUT3 = Ch 5&6
OUT4
OUT4 = Ch 7&8
OUT5
OUT5 = Ch 9&10
OUT6
OUT6 = Ch 11&12
OUT7
OUT7 = Ch 13&14
OUT8
OUT8 = Ch 15&16
For simplicity, only OUT1 is shown.
For OUT2 selections are CH34 (Ch 3 & 4) or DE (Dolby-E)
For OUT3 selections are CH56 (Ch 5 & 6) or DE
CH12
For OUT4 selections are CH78 (Ch 7 & 8) or DE
DE
For OUT5 selections are CH9A (Ch 9 & 10) or DE
For OUT6 selections are CHBC (Ch 11&12) or DE
For OUT7 selections are CHDE (Ch 13&14) or DE
For OUT8 selections are CHFG (Ch 15&16) or DE
Sets the volume for the headphone.
Selects the source for the headphone monitoring
With this control you can set the headphone volume to one of 16 levels.
Total adjustment range is over 50 dB. Level 00 is the lowest volume and is
effectively mute.
Revision 1.2
Advertisement
Table of Contents
