Table of Contents
Advertisement
2.6 PLC SWITCH
When the menu key
The control signals for operation are assigned by using user PLC. The PLC-SWITCH screen enables
you to set each control signal to ON or OFF. (A maximum of 32 signals)
This screen is created with the user PLCs,
so each screen will differ. Refer to the
instruction manual issued by the machine
maker.
2.6.1 PLC Switch ON and OFF Operation
Set the number of the switch to be set to ON in # ( ) and press the
is set to the up position.
In this state, the switch function becomes effective and is controlled.
To set OPTIONAL STOP to ON.
Set 4 in # (
).
Press the
key.
INPUT
The switch mark of OPTIONAL STOP is
set to the up position, indicating the
switch ON state.
To set the up-position switch (ON state) to OFF (down-position switch), set the number of the ON-
state switch in # ( ) and press the
The PLC switch names (message display) and the function to reverse selected message display are
prepared by using user PLC. These vary depending on the machine maker.
is pressed, the PLC SWITCH screen is displayed.
PLC-SW
key.
INPUT
[PLC SWITCH]
#
1
AUTO RESTART
2
BLOCK DELETE
3
MANUAL ABS
4
OPTIONAL STOP
5
HANDLE IT
6
7
8
#( )
RESERCH
PLC-SW
[PLC SWITCH]
#
1
AUTO RESTART
2
BLOCK DELETE
3
MANUAL ABS
4
OPTIONAL STOP
5
HANDLE IT
6
7
8
#( )
RESERCH
PLC-SW
COM-VAR
I-68
2. Monitor
2.6 PLC SWITCH
PARAM
6. 1/2
9
10
AUTO POWER OFF
11
12
13
14
15
16
COM-VAR
LOC-VAR
MENU
key. The mark of the switch
INPUT
PARAM
6. 1/2
9
10
AUTO POWER OFF
11
12
13
14
15
16
LOC-VAR
MENU
Advertisement
Table of Contents
