Mitsubishi Electric EZMotion-NC E68 Series Operation Manual page 395

6.16.4 Parameters
(1) Designation of deceleration check
Base specification parameters
# Items
1193 Inpos The setting is selected with "#1306 InpsTyp Deceleration check
specification type".
0: Deceleration check method 1
1: Validate in-position check
Deceleration
check
method 1
Validate
in-position
check
1223 Aux07 Deceleration
(bit1) check
method 2
1306 InpsTyp Deceleration
check
specification
type
(2) Deceleration check during opposite direction travel
Base specification parameters
# Items
G1 → G0
1502 G0Ipfg
deceleration
check
G1 → G1
1503 G1Ipfg
deceleration
check
Specify the deceleration check method for G0.
0: Command deceleration check
1: In-position check
Specify the deceleration confirmation method for the
positioning or cutting command.
0: G0, G1+G9 Command deceleration check
1: G0, G1+G9 In-position check
Select the deceleration check method in G1+G9.
0: Command deceleration check in G1+G9
1: In-position check in G1+G9
The deceleration check is not performed except
G1+G9.
When "#1306 InpsTyp deceleration check specification
type" is set to 1 (Deceleration check specification type
2), this parameter will be invalid.
Select the parameter specification type for the G0 or G1
deceleration check.
0: Deceleration check specification type 1
G0 is specified with "#1193 inpos", and G1+G9
with "#1223 aux07/BIT1".
1: Deceleration check specification type 2
G0 or G1+G9 is specified with "#1193 inpos".
0: Do not perform a deceleration check when the
move direction is changed from G1 to G0.
1: Perform a deceleration check when the move
direction is changed from G1 to G0.
0: Do not perform a deceleration check when the
move direction is changed from G1 to G1.
1: Perform a deceleration check when the move
direction is changed from G1 to G1.
II -34
6. Operation Panel Switch Functions
6.16 Deceleration Check
Details
Details
Setting range
0/1
0/1
0/1
0/1
Setting range
0/1
0/1