Table of Contents
Advertisement
Refer to "3 (II). Tool Offset (M system)" for M system.
(3) Incrementation when using one tool with multiple compensation Nos.
With this function, each registered T No. (tool No. + compensation No.) has independent USED
data, so the count for a tool using multiple compensation Nos. is incremented for each
compensation No.
Thus, life management for that tool's USED data is carried out with the total of the USED data for
each compensation. Because of this, when only one # No. is looked at on the screen, the tool
status (ST) may be 2 (life-reached tool), although that tool's USED data has not yet reached the
life of the tool.
The total of the currently selected tool's USED data appears in "TOTAL" of the <CHOSEN TOOL>
column on Page 1.
Example of the screen display when using multiple compensation Nos.
• Time method (life: 100000 min.)
#
TOOL No. CMP.No. USED(MIN) ST
1
101010
2
101010
3
101010
4
202020
5
202020
6
202020
7
303030
∗ The life of tool 101010 is the total
usage time of #1 to #3.
3.5.3 Parameters
The tool life management specifications will differ according to parameter #1096 T_Ltype and #1106
Tcount. Confirm the explanation for the relevant setup parameter data item.
1
40000
2
2
40000
2
3
30000
2
4
20000
1
5
20000
1
6
15000
1
7
0
0
3. Tool Offset (L system)
3.5 Tool Life Management II
• Count method (life: 100000 times)
#
TOOL No. CMP.No. USED(SET) ST
1
101010
2
101010
3
101010
4
202020
5
202020
6
202020
7
303030
∗ The life of tool 101010 is the total
count of #1 to #3.
I-104
1
50000
2
2
50000
2
3
0
2
4
40000
1
5
40000
1
6
0
1
7
0
0
Advertisement
Table of Contents
