Table of Contents
Advertisement
4.2.3 Axis Parameters
[AXIS PARAMETER]
#
8201 AX. RELEASE
8202 OT-CHECK OFF
8203 OT-CHECK-CANCEL
8204 OT-CHECK-N
8205 OT-CHECK-P
8206 TOOL CHG.P
8207 G76/87 IGNR
8208 G76/87 (-)
8209 G60SHIFT
8210 OT INSIDE
8211 MIRR. IMAGE
8212
# (
)
WORK
PROCESS
#
Item
8201 AX. RELEASE
8202 OT-CHECK OFF
8203 OT-CHECK-CANCEL When the simple absolute position method (#2049
8204 OT-CHECK-N
<X>
<Y>
0
0
0
0
0
0
1.000
1.000
1.000
1.000
0.000
0.000
0
0
0
0
0.000
0.000
0
0
0
0
DATA(
)
(
)
I/O PAR
Select the function to remove the control axis from
the control target.
0: Control as normal.
1: Remove from control target.
Select the stored stroke limit II function set in #8204
and #8205.
0: Stored stroke limit II valid
1: Stored stroke limit II invalid
type is 9) is selected‚ the stored stroke limits I, II(or
IIB), IB will be invalid until the first zero point return is
executed after the power is turned ON.
0: Stored stroke limit II valid (according to #8202)
1: Stored stroke limit II invalid
(Note) Temporary cancel of #8203 soft limit affects
all the stored stroke limits.
This sets the coordinates or the lower limit
coordinates of the prohibited range of stored stroke
limit IIB of the (–) direction in the moveable range of
the stored stroke limit II.
If the sign and value are the same as #8205, the
stored stroke limit II(or IIB) will be invalid.
When II is selected, the entire range will be
prohibited.
If the stored stroke limit IIB function is selected, the
prohibited range will be between two points even
when #8204 and #8205 are set in reverse.
4.2 Machining Parameters
<Z>
0
0
0
1.000
1.000
0.000
0
0
0.000
0
0
(
)
SETUP
Contents
I-152
4. Parameters (User)
PARAM
1.6/8
MENU
Setup range (unit)
0/1
0/1
0/1
±99999.999 (mm)
Advertisement
Table of Contents
