Table of Contents
Advertisement
6.5 PROGRAM FILE
When the menu key
The PROGRAM FILE screen lists the user-prepared machining programs stored in memory.
Item
PROGRAM ENTRY and
REMAIN
CHARACTER and REMAIN The number of characters already registered as user machining programs
<PROGRAM> <CHR> <ST>
<COMMENT>
(Note 1) If a large number of short programs are registered or edit operation is performed frequently,
the memory use efficiency lowers because of the memory configuration and (CHARACTER
+ REMAIN) becomes less than the maximum number of available characters that are
stored. If the difference between them is extremely large, the condense function can be
used to improve the memory use efficiency.
(Note 2) If preparing comment, space (
registration for efficient use of memory.
is pressed, the PROGRAM FILE screen is displayed.
FILE
The number of programs already registered as user machining programs is
displayed in the PROGRAM ENTRY field. The remaining number of
programs that can be registered is displayed in the REMAIN field. The sum
total of the PROGRAM ENTRY and REMAIN values is the maximum
number of registered programs. This value is defined in the specifications.
is displayed in the CHARACTER field. The remaining number of characters
that can be registered is displayed in the REMAIN field. The sum total of the
CHARACTER and REMAIN values is the maximum number of stored
characters. This value is defined in the specifications.
A value in 250-character units is displayed in REMAIN.
<PROGRAM>
The numbers of the already registered machining
program are indicated in the ascending order in the range
of 1 to 99999999.
<CHR>
The number of stored characters is indicated for each
machining program number.
<ST>
The machining program status is indicated.
<COMMENT>
A summary of the machining program functions,
specifications, and applications can be displayed as a
comment of up to 18 alphanumeric and symbol
characters.
It can also be specified during input from paper tape. It
can also be set on the screen.
) can be written in it. But, the space is ignored after
SP
I-250
6. Data In/Out
6.5 PROGRAM FILE
[PROGRAM FILE]
PROGRAM ENTRY 20 REMAIN
180
CHARACTER
21234 REMAIN 39750
<PROGRAM> <CHR> <ST> <COMMENT>
1
123
TESTCUT
2
10
100
1000
1001
1020
INPUT
OUTPUT
ERASE
Explanation
IN/OUT
4.1/1
<PROGRAM> <CHR> <ST> <COMMENT>
2000
456
0(
) COMMENT (
)
FILE
MENU
(Not used)
Advertisement
Table of Contents
