Restoration Operations - Mitsubishi Electric EZMotion-NC E68 Series Operation Manual

4.5.2 Restoration Operations

The parameters are restored from the backup cassette to the NC with the following steps.
(1)
Execute emergency stop.
"EMG EMERGENCY" will appear at the
operation message area.
(2)
Input "2" at the setting area # ( ),
and press the
INPUT
"PLC STOP Y/N" will appear at the
message area.
The error "E330 Maintenance Cassette
error" will occur if the backup cassette is
not mounted.
(3)
Input "Y" at the setting area (
and press the
INPUT
"RESTORE EXEC Y/N" will appear at
the message area.
(4)
Input "Y" at the setting area (
and press the
INPUT
(a) The message "RESTORE EXECUTION"
will appear while the parameters are
being restored.
(b) The message "RESTORE COMPLETE" will
appear when the restoration is completed.
(Note 1) Other screens cannot be opened during this operation.
(Note 2) If the PLC is already stopped, step (3) is skipped.
The PLC will not start running even when the operations are completed.
(Note 3) If the
INPUT
SETTING ERROR" will occur.
(Note 4) Even if the PLC RUN/STOP changeover is prohibited (R2925/bit2 ON), the PLC will stop
with step (3).
(Note 5) The data (local variables, machining programs, MDI programs and fixed cycle
subprograms) corresponding to ALL2, and the title screen data are not backed up in the
FROM cassette backed up with the E60 system version A unit. Thus, the data will not be
restored even when restoration is executed.
key.
),
key.
),
key.
key is pressed without inputting anything at the "~Y/N" display, the error "E01
#( ) ( )
EMG EMERGENCY
WORK PROCESS I/O PAR
#(2) ( )
EMG EMERGENCY
WORK PROCESS I/O PAR
#(2) ( Y)
EMG EMERGENCY
WORK PROCESS I/O PAR
#(2) ( Y)
EMG EMERGENCY
WORK PROCESS I/O PAR
#( ) ( )
EMG EMERGENCY
WORK PROCESS I/O PAR
I-166
4. Parameters (User)
4.5 BACKUP Screen
SETUP MENU
PLC STOP Y/N
SETUP MENU
RESTORE EXEC Y/N
SETUP MENU
RESTORE EXECUTION
SETUP MENU
RESTORE COMPLETE
SETUP MENU