Table of Contents
Advertisement
(Note 1) If the type is BCD output and a negative number is set, the positive value converted from it
will be output.
(Example) Manual numeric command
(Note 2) If the number of digits specified in the command exceeds the setting range, the most
significant digit will be lost.
(Example)
(5) Other notes on operation
(1) When a minus command is set:
Before setting the numeric, press the
(Example) If S-150 is specified:
Press address key
S
key
1
5
0
Press the
key.
INPUT
1) A minus value will be output, but a
positive value will display.
(2) When manual numeric command operation stops halfway:
If the operation is desired to be stopped before input after pressing the address key, press any
non-numeric key.
• If a manual numeric command address-key such as M, S, T is pressed, the previous
operation will stop. In this case, the next manual numeric command sequentially begins.
• If an axis address key (X, Y, or Z, etc.) is pressed, the manual numeric command will stop.
In this case, the origin zero or counter zero mode is then entered.
• If the
SHIFT
POSITION screen is blanked.
• If one of the following keys is pressed, the operation will not stop:
1) Position display function key
2)
key pressed before a numeric is set (will be processed as a minus command.)
3)
DELETE
INS
(3) The macro interruption codes (M96, M97) and subprogram call codes (M98, M99) will not be
processed even if these codes are issued.
(4) No surface speed command is available.
In the constant surface speed mode, no command is processed, if specified.
M -100
M
1234
5
. Then, press
in order.
C.B
keys are pressed, the manual numeric command will stop. In this case, the
CAN
key when a numeric has been set (The set data will be deleted.)
Output
M 100
M
2345
1
Most significant digit is lost.
key.
S-150
S 150
MONI-
TOR
I-24
2. Monitor
2.1 POSITION
Advertisement
Table of Contents
