Table of Contents
Advertisement
4.6 Handle Feed Mode
The controlled axis can be moved by turning the manual handle.
The travel distance per graduation of the handle depends on how the HANDLE/INCREMENTAL
MAGNIFICATION switch is set.
The axis that can be moved by using the manual handle is determined by setting the HANDLE FEED
AXIS SELECT switch.
Operation procedure
Using the MODE SELECT switch, select the handle feed mode.
Using the HANDLE FEED AXIS SELECT switch, select the controlled axis to be
moved.
Using the HANDLE/INCREMENTAL MAGNIFICATION switch, set the travel
distance per graduation of the handle.
Move the axis by turning the HANDLE
in any desired direction.
4. Operation Mode
4.6 Handle Feed Mode
-
1 0
1 0
II-12
HANDLE
00
+
7 2
0 1
Advertisement
Table of Contents
