Mitsubishi Electric EZMotion-NC E68 Series Operation Manual page 29

5) Data in parentheses where the cursor exists is erased by pressing the
Display is made in the setting area as
shown in the right.
C.B
If you press the
CAN
6) Data in all parentheses in the setting area is erased by pressing
Display is made in the setting area as
shown in the right.
C.B
If you press
SHIFT
CAN
7) The cursor in parentheses is moved one column to the left or right by pressing the
key desired character of data entered by using the data keys can be corrected.
Display is made in the setting area as
shown in the right.
If you make successive four strokes of
the key,
If you press ,
3
2 is corrected to 3 and the cursor is moved one column to the right.
If you press the
The cursor is only moved one column to the right.
If you press
0 0
SP SP
The character at the cursor position is rewritten and the cursor is also moved one column to
the right. Data is corrected in sequence.
(Note 1) If is pressed when the cursor exists in the right end within one parenthesis, the
cursor is moved to the right end within the following parenthesis part; if
pressed when the cursor exists in the left end within one parenthesis, the cursor is
moved to the right end within the preceding parentheses.
key,
,
key,
,
0
SP
I-14
1. Setting and Display Unit Operation
1.5 Data Setting Method
C.B
CAN
# ( 10) DATA (
# ( 10) DATA (
C.B
SHIFT
CAN
# ( 10) DATA (
# ( ) DATA (
# ( 10) DATA (
# ( 10) DATA (
# ( 10) DATA (
# ( 10) DATA (
# ( 10) DATA (
key.
12.345)
)
.
12.345)
)
or
12.345)
12.345)
13.345)
13.345)
13.000)
is