Ic Card Operation - Mitsubishi Electric EZMotion-NC E68 Series Operation Manual

8. IC Card Operation

When the function selection key
Input/output menu (No. 2 to 5)
Diagnosis menu (No.5 to 8)
Diagnosis menu (No.1 to 4)
Diagnosis menu (No.13)
Diagnosis menu (No.9 to 12)
Input/output menu (No.1), IC card operation menu (No.1)
IC card operation menu
No.1
DIAGN menu
Input/Output menu
<Before using the IC card>
(1) Confirm if the IC card is installed.
(2) Do not insert/remove the IC card while the NC power is ON. If inserted/removed while operating,
transferring, erasing, formatting or comparing, the IC card may be damaged.
(3) When formatting the IC card on PC, use the FAT16 format. If formatted with other than FAT16 format,
IC card cannot be read in the NC side.
(4) In order to use this function, additional hardware (Hereinafter referred to as H/W) FCU6-EP105-1
(HR253, HR551,F161) is required.
DIAGN
is pressed, the following menu is displayed.
IN/OUT
IC-CARD
SELECTION
Refer to the section on diagnosis.
Refer to the section on data input/output.
I-299
8. IC Card Operation
INPUT OUTPUT
ABS-SRV ADJUST
ALARM SERVO
PLC TRACE
AUX-PRM AUX-MON SUPPORT
COPY IC DATA
Previous
page key
Menu selection keys
I/O
FILE
ERASE FILE MENU
HISTORY CONFIG MENU
SPINDLE PLC-I/F MENU
MENU
MENU
NSK-TERMINAL
MENU
Next
page key
MENU
MENU