Table of Contents
Advertisement
(b) For a flat cable type connector with latches, open the latches in the directions of the arrows, and
pull the connector off.
(c) For a flat cable type connector without latches, hold the connector with a thumb and forefinger,
and pull the connector off.
(2) Pull
(d) For the screw fixed type connector, loosen the two fixing screws, and pull the connector off.
(2) Pull
CAUTION
An incorrect connection can damage the device. Always connect the cable to the
designated connector.
Do not connect or disconnect the connection cables between each unit while the
power is ON.
Do not connect the cable by pulling on the cable wire.
6. Daily Maintenance and Periodic Inspection and Maintenance
(2) Pull
(1) Hold with thumb and forefinger.
(1) Loosen
III-39
6.3 Replacement Methods
(1) Open
(2) Pull
(1) Loosen
Advertisement
Table of Contents
